Plaid Mod Podge Gloss Waterbase Sealer, Glue & Finish

Plaid Mod Podge Gloss Waterbase Sealer, Glue & Finish is a multi-purpose, all-in-one decoupage glue, sealer, and finish. It is suitable to for use on a wide variety of surfaces including fabric, wood, paper and other porous materials like candles, foam, plastic, and terra-cotta.

As its name suggests, it can be used as a glue, a seal, and to protect surfaces or items before using in craft projects. It is formulated to create a gloss finish. Plaid Mod Podge Gloss Waterbase Sealer, Glue & Finish dries clear, holds tight, and can be sanded to a smooth finish. This water-based solution is Certified AP non-toxic.

Plaid Mod Podge Gloss Waterbase Sealer, Glue & Finish is also created to dry quickly for multiple coats build up. It can be applied using a soft bristle brush or a sponge applicator. After applying, allow the solution to cure for about 4 weeks. Then apply Clear Acrylic Sealer over the cured Mod Podge to remove tackiness.

Plaid Mod Podge Gloss Waterbase Sealer, Glue & Finish should be stored at room temperature. Immediately close the container after each use. In case it gets on surfaces other than your project, you can clean it up easily using soapy water while the product is still wet.

Use as Glue

To use as glue, apply moderate coat to the backside of the fabric or paper and onto a surface. Position the fabric or paper on the surface and smooth out air bubbles and wrinkles.

Use as Sealer:

To use as a sealer, apply thin coat and allow the solution to dry for about 20 – 30 minutes before applying the next coat. Also, please take note that this is not an all-purpose sealer. It is best used as sealer for decoupage projects.

Use as Quick Finish:

To use as quick finish, you can apply smooth think coat on a surface using soft bristle brush or foam applicator.

Use as Built-Up Finish:

To use as built-up finish, you will need to apply 5 coats. Just like when using as a sealer, allow the formula to dry for about 20-30 minutes before applying the next coat. Sand using 400-grit sandpaper to smoothen. Wipe it dry and polish using #0000 steel wool. Then wipe the surface with damp cloth. You may also apply more than 5 coats and wet sand.

Use as Textured Finish:

To use for textured finish, apply thick coat. Imitate the artist’s brush stroke or stipple the surface with sponge applicator.

Use as Finished Puzzle Saver:

If you want to protect your work surface under a finish puzzle, apply this all-in-one sealer, glue, and finish evenly over the entire puzzle using a squeegee. Make sure to cover all the cracks and allow the solution to try complete for about 20 to 30 minutes, then do the same on the back of the puzzle. Apply additional coats for extra protection and allow it to cure for about 4 weeks.

Plaid Mod Podge Gloss comes in four sizes:

• 59ml - 2fl oz

• 118ml - 4fl oz

• 236ml - 8fl oz

• 474ml - 16 fl oz

• 976ml - 32 fl oz

• 1.89lt  - 64 fl oz

• 3.78lt - 1 U.S Gallon